Changes between Version 13 and Version 14 of DemoIntegrateTilted


Ignore:
Timestamp:
Jul 30, 2011 5:53:30 PM (12 years ago)
Author:
toby
Comment:

--

Legend:

Unmodified
Added
Removed
Modified

  • DemoIntegrateTilted

    v13 v14  
    11= Integration of area detector data in GSAS-II =
    22
    3 ''In this demo, data collected with a GE(?) area detector, intentionally tilted at 45 degrees, are used. Note that menu entries are listed below as Help/About GSAS-II, which lists first the name of the menu (here "Help") and second the name of the entry in the menu (here "About GSAS-II").''
     3''In this demo, data collected with a GE(?) area detector, intentionally tilted at 45 degrees, are used. Note that menu entries are listed '''in bold face''' below as'' '''Help/About GSAS-II''''', which lists first the name of the menu (here "Help") and second the name of the entry in the menu (here "About GSAS-II").''
    44
    55== Prerequisite: [DemoCalibrateTilted Calibration Demo] ==
    … …  
    99=== Step 1: Clear calibration plot   ===
    1010
    11 Assuming the previous step was calibration, the image plot will show the located rings or the picked points. These are no longer needed. The Image Controls/Clear Calibration menu entry removes these intermediate results, ''but does not clear the calibration results''. Use of this menu item is not required, but does speed future display of results.
     11Assuming the previous step was calibration, the image plot will show the located rings or the picked points. These are no longer needed. The '''Image Controls/Clear Calibration''' menu entry removes these intermediate results, ''but does not clear the calibration results''. Use of this menu item is not required, but does speed future display of results.
    1212
    1313=== Step 2: Integration Settings ===
    1414
    15 In the simplest case, all that is needed is to click on the "Do full integration?" checkbox and likely adjust the inner and outer 2-theta values with the two "Inner/Outer 2-theta" controls. For the La_hex_+45deg-00015.tif image loaded before, good values are 0.5 and 7 degrees.
     15In the simplest case, all that is needed is to click on the "Do full integration?" checkbox and likely adjust the inner and outer 2-theta values with the two "Inner/Outer 2-theta" controls. For the {{{La_hex_+45deg-00015.tif}}} image loaded before, good values are 0.5 and 7 degrees.
    1616
    1717It is helpful to see the two-theta limits on the plot visually, while adjusting the two-theta range. This is done by clicking on the "Show integration limits?" checkbox. Note that inner limit is shown as a green ellipse and the outer is shown as a red ellipse ([https://subversion.xor.aps.anl.gov/trac/pyGSAS/attachment/wiki/DemoIntegrateTilted/d2w1.jpg view]).
    … …  
    2929=== Step 3: Perform integration ===
    3030
    31  Use the Image Operations/Integrate image data menu item to start the integration. This will take at least a few seconds. If multiple images have been read in, the Integrate All menu item can be used. This is most useful when the "Use as Default" option is in use for one image.
     31 Use the '''Image Operations/Integrate''' image data menu item to start the integration. This will take at least a few seconds. If multiple images have been read in, the '''Integrate All''' menu item can be used. This is most useful when the "Use as Default" option is in use for one image.
    3232
    3333 At this point the data tree window will have a new entries for each azimuthal "slice" added to the data tree