EXPGUI top Next page (Menus) Previous page

EXPGUI, part 7

A.7 Preferential Orientation Pane

The Preferential Orientation Pane is used to control parameters related to fitting parameters using the March-Dollase formulation or the spherical harmonic formulation for preferred orientation. Note that GSAS allows both sets of terms to be used at the same time, but it seems unlikely that anyone would actually want to try this.

A.7.a March-Dollase

In this model one or more axes are designated as directions [designated by (hkl)] where crystallites are over (Ratio > 1) or underrepresented (Ratio < 1). The checkbox to the right of the Ratio value determines if it will be refined.
EXPGUI Screen snapshot
If more than one axis is present, one must define the relative fraction of preferred orientation for each direction. These fractions are normalized, so do not vary the fractions for all directions in a phase.
EXPGUI Screen snapshot
If "Multiple Histogram Selection" mode is set to any value other than "Off", all terms are displayed for all selected histograms. No attempt is made to group terms or flags.

A.7.b Spherical harmonic

The spherical harmonic formulation, also referred to as an "orientation distribution function" defines a set of terms to treat preferential orientation as a function of the sample symmetry and as a function of the Laue phase symmetry of the phase and the selected order expansion. Note that only one set of terms is used for each phase, so this function should not be used when the different types of powder data, for example neutron and x-ray data, are used in a single refinement. The setting angles define the orientation of the sample with respect to the detectors and are typically used for texture analysis using TOF data only.
EXPGUI Screen snapshot
When more than one phase is present, the phase is selected with the buttons in the upper left. Note that when additional terms are added by increasing the spherical harmonic order, the new parameters default to zero. Thus, is the order is set to zero and then reset to the previous non-zero value, all terms will be reset to zero. Also, as in EXPEDT, when the sample symmetry is changed, the order is reset to zero.

EXPGUI top Next page (Menus) Previous page
Brian Toby (Brian.Toby@NIST.GOV)
$Revision: 511 $ $Date: 2009-12-04 23:07:23 +0000 (Fri, 04 Dec 2009) $