While normally I would recommend refining the lattice first and then in a subsequent refinement cycle also refining the zero point correction in a later cycle of refinement, with a cubic cell and a small zero-point error it is possible to refine both together. Set the refinement flag for the lattice (shown above) and the zero point correction (shown below).
and then start GENLES, as was done before.
A dramatic improvement is seen both through the agreement factors (above) and as seen in the plot (below).
At this point it is a good idea to run POWPREF and GENLES again, since peak positions have moved. This causes the Reduced Chi**2 to drop from 14.9 to 13.5.
(.EXP Snapshot: garnet6.exp )
Brian Toby (Brian.Toby@NIST.GOV)
$Revision: 173 $ $Date: 2009-12-04 23:01:37 +0000 (Fri, 04 Dec 2009) $