Changeset 860


Ignore:
Timestamp:
Dec 4, 2009 5:13:17 PM (11 years ago)
Author:
toby
Message:

# on 2005/12/16 00:42:19, toby did:

pane --> panel

File:
1 edited

Legend:

Unmodified
Added
Removed
  • trunk/doc/expgui6.html

    • Property rcs:date changed from 2002/04/12 19:49:04 to 2005/12/16 00:42:19
    • Property rcs:lines changed from +3 -4 to +7 -7
    • Property rcs:rev changed from 1.11 to 1.12
    r572 r860  
    3232</h1></center>
    3333
    34 <h3>A.6 Constraints pane</h3>
     34<h3>A.6 Constraints panel</h3>
    3535<DL><DL>
    3636GSAS offers two types of restraints that can be included in a model.
     
    4141by grouping parameters so that a single shift (possibly scaled) is
    4242applied to each parameter in the group.
    43 The constraints pane is used to set these "hard constraints."
     43The constraints panel is used to set these "hard constraints."
    4444At this time the only constraints that can be set in EXPGUI are on atomic
    4545and profile profile (others can be set in EXPEDT).
     
    6060<H4>Atom Constraints</H4>
    6161<DL><DL>
    62 The atom constraints editing pane appears below. Note that constraints can
     62The atom constraints editing panel appears below. Note that constraints can
    6363be listed sorted by constraint number, phase number, lowest atom number or
    64 variable by clicking on the buttons at the top of the pane.
     64variable by clicking on the buttons at the top of the panel.
    6565<P>
    6666To delete one or more constraints, click on the appropriate checkbuttons in the <B>Delete</B> column and the press the Delete button, below.
     
    130130<DL><DL>
    131131Constraints for a macromolecular phase can be entered on a
    132 pane similar to the Atomic Constraints, except that the phase number
     132panel similar to the Atomic Constraints, except that the phase number
    133133does not appear anywhere (since the macromolecular phase must
    134134be phase #1). The variables that can be constrained for
     
    142142<H4>Profile Constraints</H4>
    143143<DL><DL>
    144 The profile constraints editing pane appears below. Profile constraints
     144The profile constraints editing panel appears below. Profile constraints
    145145are used to relate the shifts applied to profile terms for different
    146146phase/histogram combinations. Profile terms are identified by number,
Note: See TracChangeset for help on using the changeset viewer.